No products were found matching your selection.
Other Related Products
-
Conspicuity tape DOT C2 data should define material construction, dimensions, photometric performance, adhesive behavior, temperature limits, surface compatibility, and the conditions behind each result. This record is for pressure-sensitive microprismatic vehicle marking sheeting, not ordinary reflective tape. Regulatory minimums support screening, while peel behavior, edge stability, weathering response, and removal observations should be confirmed by sample testing on the intended coated surface before full use.
-
- Regular widths: 25 mm, 50 mm, 100 mm, with custom stair strip sizes
- Colors: black, gray, yellow-black warning, or project colors
- Surface: mineral grit abrasive layer for high-friction shoe contact
- Backing: PVC/PET film, with foil-backed option for textured metal steps
- Adhesive: pressure-sensitive acrylic adhesive with release liner
- Supply format: rolls, pre-cut strips, rounded-corner die cuts
-
- Common Size: 1.22 m x 45.7 m roll
- Color: Yellow-green surface
- Material: PVC/PET based film
- Structure: Surface film + photoluminescent layer + adhesive
- Backing: Permanent acrylic adhesive with release liner
- Use: Exit signs, stairs, corridors, route markers
-
- Size: 1 in, 1 3/16 in, 1.5 in
- Length: 150 ft, 300 ft, 600 ft
- Material: PE, PVC, PP optional
- Colors: orange, pink, yellow, red, blue, green, white
- Structure: non-adhesive plastic ribbon
- Use: tie, wrap, knot, or staple
-
- Size: 25mm, 50mm, 75mm, 100mm, custom slit rolls
- Color: Clear transparent, light frosted grip finish
- Material: PVC or PET carrier with textured grip surface
- Adhesive: Acrylic adhesive, typical 80um-120um layer
- Thickness: Typical total thickness 0.65mm-0.85mm
- Supply: Roll stock for stair tread cutting
-
- Material: PVC/vinyl film
- Adhesive: Rubber pressure-sensitive adhesive
- Common widths: 48 mm, 50 mm, 75 mm, 100 mm
- Common colors: Yellow, red, blue, green, white, black, striped
- Roll length: 30 m, 33 m, 50 m, custom length
- Use surface: Clean concrete, epoxy floor, sealed industrial floor
-
- Roll size: 1.22 m x 45.7 m
- Width tolerance: +/- 2 mm typical
- Colors: white, yellow, red, blue, green, orange, black
- Structure: PVC, PET, PC, or PMMA-based film
- Adhesive: permanent pressure-sensitive adhesive
- Liner: release paper or film liner
-
- Typical Thickness: 1.6-2.2mm
- Colors: White, yellow, red, blue, black
- Material: Hot-melt thermoplastic compound
- Reflective Structure: Embedded glass beads
- Installation: Torch heating, compression, cooling
- Uses: Lines, arrows, symbols, crosswalks
-
DOT trailer reflective tape requirements combine vehicle eligibility, placement dimensions, material identification, optical performance, adhesive behavior, and installation control. This reference applies to pressure-sensitive red-and-white conspicuity sheeting used on qualifying commercial trailers and semitrailers. Regulatory dimensions are mandatory where applicable, while thickness, peel adhesion, holding power, temperature, and weathering values remain grade-specific or project-confirmed. Verify…
