No products were found matching your selection.
Other Related Products
-
- Common size: 10mm-500mm width, 30m-1000m length
- Color: Silver, red, blue, yellow, or custom surface color
- Material: Aluminum foil, PET, paper, PTFE glass, or laminated film
- Structure: Single coated, double coated, or non-adhesive foil strip
- Thickness: 0.08mm-0.28mm typical total thickness
- Supply:Slit rolls, sample rolls, jumbo rolls, or die-cut pieces
-
- Typical Thickness: 1.6-2.2mm
- Colors: White, yellow, red, blue, black
- Material: Hot-melt thermoplastic compound
- Reflective Structure: Embedded glass beads
- Installation: Torch heating, compression, cooling
- Uses: Lines, arrows, symbols, crosswalks
-
- Common Size: 1.22 m x 45.7 m roll
- Color: Yellow-green surface
- Material: PVC/PET based film
- Structure: Surface film + photoluminescent layer + adhesive
- Backing: Permanent acrylic adhesive with release liner
- Use: Exit signs, stairs, corridors, route markers
-
- Material: PE/OPP laminated film
- Tracer wire: SS304 or SS316
- Wire diameter: 0.4mm, 0.5mm, 0.7mm
- Tape thickness: 100um, 130um, 150um
- Width/length: 75mm-300mm, 100m-500m
- Color/print: APWA colors, custom legends
-
DOT trailer reflective tape requirements combine vehicle eligibility, placement dimensions, material identification, optical performance, adhesive behavior, and installation control. This reference applies to pressure-sensitive red-and-white conspicuity sheeting used on qualifying commercial trailers and semitrailers. Regulatory dimensions are mandatory where applicable, while thickness, peel adhesion, holding power, temperature, and weathering values remain grade-specific or project-confirmed. Verify…
-
- Common Sizes: 2 in, 3 in, 4 in widths
- Colors: Yellow, red/white, yellow/black
- Material: PVC or PET reflective film
- Structure: Glass bead or micro-prismatic
- Adhesive: Pressure-sensitive acrylic backing
- Tested Surfaces: Metal, PVC, plastic bollards
-
Common Size: 25 mm, 50 mm, 100 mm widths; custom lengths available
Color: Transparent, translucent white, light gray options
Material: PEVA/PVC textured film with pressure-sensitive acrylic adhesive
Thickness: Approx. 0.45-0.75 mm depending on grade
Adhesive: Waterproof acrylic adhesive compatible with smooth tile surfaces
Use Area: Bathroom tiles, shower floors, bathtub edges, wet ceramic tile areas
-
- Size: 1 in, 1 3/16 in, 1.5 in
- Length: 150 ft, 300 ft, 600 ft
- Material: PE, PVC, PP optional
- Colors: orange, pink, yellow, red, blue, green, white
- Structure: non-adhesive plastic ribbon
- Use: tie, wrap, knot, or staple
-
- Regular widths: 25 mm, 50 mm, 100 mm, with custom stair strip sizes
- Colors: black, gray, yellow-black warning, or project colors
- Surface: mineral grit abrasive layer for high-friction shoe contact
- Backing: PVC/PET film, with foil-backed option for textured metal steps
- Adhesive: pressure-sensitive acrylic adhesive with release liner
- Supply format: rolls, pre-cut strips, rounded-corner die cuts
