No products were found matching your selection.
Other Related Products
-
- Material: PE, LDPE, or LLDPE non-adhesive film
- Thickness: 4 mil / 0.1 mm, typical tolerance +/- 10%
- Widths: 3 inch, 6 inch, 12 inch, or 50 / 75 / 100 / 150 mm
- Roll lengths: 100 m, 250 m, 500 m, or 1000 ft
- Printing: Custom legend, language, direction, and 500 mm – 1000 mm repeat spacing
- Packing:Roll, carton, batch label, and pallet identification available
-
Warning tapes for the electrical industry do not perform one single job. A temporary maintenance boundary, an adhesive line around electrical equipment, and a buried warning layer above a power route create different demands on visibility, attachment, durability, and removal. The selection should start with the work condition: temporary or fixed, adhesive or non-adhesive, above…
-
- Common Size: 1.22 m x 45.7 m roll
- Color: Yellow-green surface
- Material: PVC/PET based film
- Structure: Surface film + photoluminescent layer + adhesive
- Backing: Permanent acrylic adhesive with release liner
- Use: Exit signs, stairs, corridors, route markers
-
A reliable tape for warehouse floor marking must do more than create a visible line. It must match the traffic pattern, floor condition, cleaning routine, operating temperature, and future removal plan. This solution is intended for pedestrian walkways, forklift routes, pallet locations, work cells, loading approaches, quarantine zones, and equipment-clearance boundaries. The main risks are weak contact, edge lifting, lateral movement, backing wear, adhesive transfer, and disturbance of an existing floor coating. Selection should therefore be based on the actual surface, traffic action, application pressure, bond-building time, and a representative site trial—not color or thickness alone.
-
- Common size: 10mm-500mm width, 30m-1000m length
- Color: Silver, red, blue, yellow, or custom surface color
- Material: Aluminum foil, PET, paper, PTFE glass, or laminated film
- Structure: Single coated, double coated, or non-adhesive foil strip
- Thickness: 0.08mm-0.28mm typical total thickness
- Supply:Slit rolls, sample rolls, jumbo rolls, or die-cut pieces
-
- Roll size: 1.22 m x 45.7 m
- Width tolerance: +/- 2 mm typical
- Colors: white, yellow, red, blue, green, orange, black
- Structure: PVC, PET, PC, or PMMA-based film
- Adhesive: permanent pressure-sensitive adhesive
- Liner: release paper or film liner
-
- Material: PE/OPP laminated film
- Tracer wire: SS304 or SS316
- Wire diameter: 0.4mm, 0.5mm, 0.7mm
- Tape thickness: 100um, 130um, 150um
- Width/length: 75mm-300mm, 100m-500m
- Color/print: APWA colors, custom legends
-
DOT trailer reflective tape requirements combine vehicle eligibility, placement dimensions, material identification, optical performance, adhesive behavior, and installation control. This reference applies to pressure-sensitive red-and-white conspicuity sheeting used on qualifying commercial trailers and semitrailers. Regulatory dimensions are mandatory where applicable, while thickness, peel adhesion, holding power, temperature, and weathering values remain grade-specific or project-confirmed. Verify…
-
- Size: 1 in, 1 3/16 in, 1.5 in
- Length: 150 ft, 300 ft, 600 ft
- Material: PE, PVC, PP optional
- Colors: orange, pink, yellow, red, blue, green, white
- Structure: non-adhesive plastic ribbon
- Use: tie, wrap, knot, or staple
