No products were found matching your selection.
Other Related Products
-
- Typical Thickness: 1.6-2.2mm
- Colors: White, yellow, red, blue, black
- Material: Hot-melt thermoplastic compound
- Reflective Structure: Embedded glass beads
- Installation: Torch heating, compression, cooling
- Uses: Lines, arrows, symbols, crosswalks
-
- Size: 25mm, 50mm, 75mm, 100mm, custom slit rolls
- Color: Clear transparent, light frosted grip finish
- Material: PVC or PET carrier with textured grip surface
- Adhesive: Acrylic adhesive, typical 80um-120um layer
- Thickness: Typical total thickness 0.65mm-0.85mm
- Supply: Roll stock for stair tread cutting
-
- Material: PVC/vinyl film
- Adhesive: Rubber pressure-sensitive adhesive
- Common widths: 48 mm, 50 mm, 75 mm, 100 mm
- Common colors: Yellow, red, blue, green, white, black, striped
- Roll length: 30 m, 33 m, 50 m, custom length
- Use surface: Clean concrete, epoxy floor, sealed industrial floor
-
Conspicuity tape DOT C2 data should define material construction, dimensions, photometric performance, adhesive behavior, temperature limits, surface compatibility, and the conditions behind each result. This record is for pressure-sensitive microprismatic vehicle marking sheeting, not ordinary reflective tape. Regulatory minimums support screening, while peel behavior, edge stability, weathering response, and removal observations should be confirmed by sample testing on the intended coated surface before full use.
-
- Common Widths: 2 inch, 3 inch, 6 inch, or project-specific width
- Roll Lengths: 500 ft, 1000 ft, or custom roll length
- Structure: PE or PET film with continuous aluminum foil layer
- Colors: APWA red, yellow, orange, blue, green, purple and custom colors
- Printing: Buried utility legends, 20 inch – 36 inch repeat available
- Use: Direct burial above utility lines before trench backfill
-
- Common Sizes: 2 in, 3 in, 4 in widths
- Colors: Yellow, red/white, yellow/black
- Material: PVC or PET reflective film
- Structure: Glass bead or micro-prismatic
- Adhesive: Pressure-sensitive acrylic backing
- Tested Surfaces: Metal, PVC, plastic bollards
-
- Common size: 10mm-500mm width, 30m-1000m length
- Color: Silver, red, blue, yellow, or custom surface color
- Material: Aluminum foil, PET, paper, PTFE glass, or laminated film
- Structure: Single coated, double coated, or non-adhesive foil strip
- Thickness: 0.08mm-0.28mm typical total thickness
- Supply:Slit rolls, sample rolls, jumbo rolls, or die-cut pieces
-
- Material: PE/OPP laminated film
- Tracer wire: SS304 or SS316
- Wire diameter: 0.4mm, 0.5mm, 0.7mm
- Tape thickness: 100um, 130um, 150um
- Width/length: 75mm-300mm, 100m-500m
- Color/print: APWA colors, custom legends
-
Common Size: 25 mm, 50 mm, 100 mm widths; custom lengths available
Color: Transparent, translucent white, light gray options
Material: PEVA/PVC textured film with pressure-sensitive acrylic adhesive
Thickness: Approx. 0.45-0.75 mm depending on grade
Adhesive: Waterproof acrylic adhesive compatible with smooth tile surfaces
Use Area: Bathroom tiles, shower floors, bathtub edges, wet ceramic tile areas
