No products were found matching your selection.
Other Related Products
-
- Common width: 100mm, 150mm, 200mm, 300mm, 500mm, 700mm
- Roll length: 100m, 250m, 500m
- Material: PP or HDPE mesh
- Locator element: stainless steel wire or aluminum strip
- Colors: yellow, red, blue, green, orange, or custom
- Text: custom buried utility warning text
-
- Material: PVC/vinyl film
- Adhesive: Rubber pressure-sensitive adhesive
- Common widths: 48 mm, 50 mm, 75 mm, 100 mm
- Common colors: Yellow, red, blue, green, white, black, striped
- Roll length: 30 m, 33 m, 50 m, custom length
- Use surface: Clean concrete, epoxy floor, sealed industrial floor
-
- Material: PVC wear layer
- Color: Yellow, black, red, or custom color
- Width: 50 mm / 80 mm / 100 mm
- Thickness: 0.5 mm / 0.7 mm / 1.0 mm
- Adhesive: Pressure-sensitive acrylic adhesive
- Edge: Sloped edge for lifting control
-
- Material: PE, LDPE, or HDPE film
- Common Width: 50 mm, 75 mm, 100 mm
- Thickness: 30 um-100 um
- Roll Length: 100 m, 200 m, 300 m, 500 m
- Colors: yellow/black, red/white
- Installation: tying, stapling, nailing, wrapping
-
DOT trailer reflective tape requirements combine vehicle eligibility, placement dimensions, material identification, optical performance, adhesive behavior, and installation control. This reference applies to pressure-sensitive red-and-white conspicuity sheeting used on qualifying commercial trailers and semitrailers. Regulatory dimensions are mandatory where applicable, while thickness, peel adhesion, holding power, temperature, and weathering values remain grade-specific or project-confirmed. Verify…
-
- Typical Thickness: 1.6-2.2mm
- Colors: White, yellow, red, blue, black
- Material: Hot-melt thermoplastic compound
- Reflective Structure: Embedded glass beads
- Installation: Torch heating, compression, cooling
- Uses: Lines, arrows, symbols, crosswalks
-
- Size: 25mm, 50mm, 75mm, 100mm, custom slit rolls
- Color: Clear transparent, light frosted grip finish
- Material: PVC or PET carrier with textured grip surface
- Adhesive: Acrylic adhesive, typical 80um-120um layer
- Thickness: Typical total thickness 0.65mm-0.85mm
- Supply: Roll stock for stair tread cutting
-
Common Size: 25 mm, 50 mm, 100 mm widths; custom lengths available
Color: Transparent, translucent white, light gray options
Material: PEVA/PVC textured film with pressure-sensitive acrylic adhesive
Thickness: Approx. 0.45-0.75 mm depending on grade
Adhesive: Waterproof acrylic adhesive compatible with smooth tile surfaces
Use Area: Bathroom tiles, shower floors, bathtub edges, wet ceramic tile areas
-
- Roll size: 1.22 m x 45.7 m
- Width tolerance: +/- 2 mm typical
- Colors: white, yellow, red, blue, green, orange, black
- Structure: PVC, PET, PC, or PMMA-based film
- Adhesive: permanent pressure-sensitive adhesive
- Liner: release paper or film liner
