No products were found matching your selection.
Other Related Products
-
- Typical Thickness: 1.6-2.2mm
- Colors: White, yellow, red, blue, black
- Material: Hot-melt thermoplastic compound
- Reflective Structure: Embedded glass beads
- Installation: Torch heating, compression, cooling
- Uses: Lines, arrows, symbols, crosswalks
-
- Regular widths: 25 mm, 50 mm, 100 mm, with custom stair strip sizes
- Colors: black, gray, yellow-black warning, or project colors
- Surface: mineral grit abrasive layer for high-friction shoe contact
- Backing: PVC/PET film, with foil-backed option for textured metal steps
- Adhesive: pressure-sensitive acrylic adhesive with release liner
- Supply format: rolls, pre-cut strips, rounded-corner die cuts
-
A reliable tape for warehouse floor marking must do more than create a visible line. It must match the traffic pattern, floor condition, cleaning routine, operating temperature, and future removal plan. This solution is intended for pedestrian walkways, forklift routes, pallet locations, work cells, loading approaches, quarantine zones, and equipment-clearance boundaries. The main risks are weak contact, edge lifting, lateral movement, backing wear, adhesive transfer, and disturbance of an existing floor coating. Selection should therefore be based on the actual surface, traffic action, application pressure, bond-building time, and a representative site trial—not color or thickness alone.
-
- Material: PVC wear layer
- Color: Yellow, black, red, or custom color
- Width: 50 mm / 80 mm / 100 mm
- Thickness: 0.5 mm / 0.7 mm / 1.0 mm
- Adhesive: Pressure-sensitive acrylic adhesive
- Edge: Sloped edge for lifting control
-
- Common width: 100mm, 150mm, 200mm, 300mm, 500mm, 700mm
- Roll length: 100m, 250m, 500m
- Material: PP or HDPE mesh
- Locator element: stainless steel wire or aluminum strip
- Colors: yellow, red, blue, green, orange, or custom
- Text: custom buried utility warning text
-
DOT trailer reflective tape requirements combine vehicle eligibility, placement dimensions, material identification, optical performance, adhesive behavior, and installation control. This reference applies to pressure-sensitive red-and-white conspicuity sheeting used on qualifying commercial trailers and semitrailers. Regulatory dimensions are mandatory where applicable, while thickness, peel adhesion, holding power, temperature, and weathering values remain grade-specific or project-confirmed. Verify…
-
- Size: 25mm, 50mm, 75mm, 100mm, custom slit rolls
- Color: Clear transparent, light frosted grip finish
- Material: PVC or PET carrier with textured grip surface
- Adhesive: Acrylic adhesive, typical 80um-120um layer
- Thickness: Typical total thickness 0.65mm-0.85mm
- Supply: Roll stock for stair tread cutting
-
- Common Widths: 2 inch, 3 inch, 6 inch, or project-specific width
- Roll Lengths: 500 ft, 1000 ft, or custom roll length
- Structure: PE or PET film with continuous aluminum foil layer
- Colors: APWA red, yellow, orange, blue, green, purple and custom colors
- Printing: Buried utility legends, 20 inch – 36 inch repeat available
- Use: Direct burial above utility lines before trench backfill
-
- Common Size: 1.22 m x 45.7 m roll
- Color: Yellow-green surface
- Material: PVC/PET based film
- Structure: Surface film + photoluminescent layer + adhesive
- Backing: Permanent acrylic adhesive with release liner
- Use: Exit signs, stairs, corridors, route markers
