No products were found matching your selection.
Other Related Products
-
- Common Widths: 2 inch, 3 inch, 6 inch, or project-specific width
- Roll Lengths: 500 ft, 1000 ft, or custom roll length
- Structure: PE or PET film with continuous aluminum foil layer
- Colors: APWA red, yellow, orange, blue, green, purple and custom colors
- Printing: Buried utility legends, 20 inch – 36 inch repeat available
- Use: Direct burial above utility lines before trench backfill
-
- Common width: 100mm, 150mm, 200mm, 300mm, 500mm, 700mm
- Roll length: 100m, 250m, 500m
- Material: PP or HDPE mesh
- Locator element: stainless steel wire or aluminum strip
- Colors: yellow, red, blue, green, orange, or custom
- Text: custom buried utility warning text
-
- Standard Size: 50 mm x 45.7 m
- Colors: Red-white, yellow-black, yellow, white, orange-white
- Material: PET or PVC reflective film
- Adhesive: Outdoor acrylic pressure sensitive adhesive
- Reflective Grade: Engineer grade, high intensity, microprismatic
- Format:Roll, slit roll, pre-cut strip
-
Common Size: 25 mm, 50 mm, 100 mm widths; custom lengths available
Color: Transparent, translucent white, light gray options
Material: PEVA/PVC textured film with pressure-sensitive acrylic adhesive
Thickness: Approx. 0.45-0.75 mm depending on grade
Adhesive: Waterproof acrylic adhesive compatible with smooth tile surfaces
Use Area: Bathroom tiles, shower floors, bathtub edges, wet ceramic tile areas
-
Conspicuity tape DOT C2 data should define material construction, dimensions, photometric performance, adhesive behavior, temperature limits, surface compatibility, and the conditions behind each result. This record is for pressure-sensitive microprismatic vehicle marking sheeting, not ordinary reflective tape. Regulatory minimums support screening, while peel behavior, edge stability, weathering response, and removal observations should be confirmed by sample testing on the intended coated surface before full use.
-
- Material: PVC wear layer
- Color: Yellow, black, red, or custom color
- Width: 50 mm / 80 mm / 100 mm
- Thickness: 0.5 mm / 0.7 mm / 1.0 mm
- Adhesive: Pressure-sensitive acrylic adhesive
- Edge: Sloped edge for lifting control
-
- Roll size: 1.22 m x 45.7 m
- Width tolerance: +/- 2 mm typical
- Colors: white, yellow, red, blue, green, orange, black
- Structure: PVC, PET, PC, or PMMA-based film
- Adhesive: permanent pressure-sensitive adhesive
- Liner: release paper or film liner
-
- Typical Thickness: 1.6-2.2mm
- Colors: White, yellow, red, blue, black
- Material: Hot-melt thermoplastic compound
- Reflective Structure: Embedded glass beads
- Installation: Torch heating, compression, cooling
- Uses: Lines, arrows, symbols, crosswalks
-
DOT trailer reflective tape requirements combine vehicle eligibility, placement dimensions, material identification, optical performance, adhesive behavior, and installation control. This reference applies to pressure-sensitive red-and-white conspicuity sheeting used on qualifying commercial trailers and semitrailers. Regulatory dimensions are mandatory where applicable, while thickness, peel adhesion, holding power, temperature, and weathering values remain grade-specific or project-confirmed. Verify…
