No products were found matching your selection.
Other Related Products
-
- Common Widths: 2 inch, 3 inch, 6 inch, or project-specific width
- Roll Lengths: 500 ft, 1000 ft, or custom roll length
- Structure: PE or PET film with continuous aluminum foil layer
- Colors: APWA red, yellow, orange, blue, green, purple and custom colors
- Printing: Buried utility legends, 20 inch – 36 inch repeat available
- Use: Direct burial above utility lines before trench backfill
-
- Common size: 10mm-500mm width, 30m-1000m length
- Color: Silver, red, blue, yellow, or custom surface color
- Material: Aluminum foil, PET, paper, PTFE glass, or laminated film
- Structure: Single coated, double coated, or non-adhesive foil strip
- Thickness: 0.08mm-0.28mm typical total thickness
- Supply:Slit rolls, sample rolls, jumbo rolls, or die-cut pieces
-
- Material: PE, LDPE, or LLDPE non-adhesive film
- Thickness: 4 mil / 0.1 mm, typical tolerance +/- 10%
- Widths: 3 inch, 6 inch, 12 inch, or 50 / 75 / 100 / 150 mm
- Roll lengths: 100 m, 250 m, 500 m, or 1000 ft
- Printing: Custom legend, language, direction, and 500 mm – 1000 mm repeat spacing
- Packing:Roll, carton, batch label, and pallet identification available
-
- Material: PE, LDPE, or HDPE film
- Common Width: 50 mm, 75 mm, 100 mm
- Thickness: 30 um-100 um
- Roll Length: 100 m, 200 m, 300 m, 500 m
- Colors: yellow/black, red/white
- Installation: tying, stapling, nailing, wrapping
-
Conspicuity tape DOT C2 data should define material construction, dimensions, photometric performance, adhesive behavior, temperature limits, surface compatibility, and the conditions behind each result. This record is for pressure-sensitive microprismatic vehicle marking sheeting, not ordinary reflective tape. Regulatory minimums support screening, while peel behavior, edge stability, weathering response, and removal observations should be confirmed by sample testing on the intended coated surface before full use.
-
- Typical Thickness: 1.6-2.2mm
- Colors: White, yellow, red, blue, black
- Material: Hot-melt thermoplastic compound
- Reflective Structure: Embedded glass beads
- Installation: Torch heating, compression, cooling
- Uses: Lines, arrows, symbols, crosswalks
-
- Material: PVC wear layer
- Color: Yellow, black, red, or custom color
- Width: 50 mm / 80 mm / 100 mm
- Thickness: 0.5 mm / 0.7 mm / 1.0 mm
- Adhesive: Pressure-sensitive acrylic adhesive
- Edge: Sloped edge for lifting control
-
- Common width: 100mm, 150mm, 200mm, 300mm, 500mm, 700mm
- Roll length: 100m, 250m, 500m
- Material: PP or HDPE mesh
- Locator element: stainless steel wire or aluminum strip
- Colors: yellow, red, blue, green, orange, or custom
- Text: custom buried utility warning text
-
DOT trailer reflective tape requirements combine vehicle eligibility, placement dimensions, material identification, optical performance, adhesive behavior, and installation control. This reference applies to pressure-sensitive red-and-white conspicuity sheeting used on qualifying commercial trailers and semitrailers. Regulatory dimensions are mandatory where applicable, while thickness, peel adhesion, holding power, temperature, and weathering values remain grade-specific or project-confirmed. Verify…
